• 0 Posts
  • 88 Comments
Joined 1 year ago
cake
Cake day: September 14th, 2023

help-circle






  • A relay switch could work. You would put the car 12V and ground across the coil connections, the 12V on the NO connection, the panel on the NC connection, and the power pack on the C connection. Make sure you get a 12VDC relay.

    Are you going to have the panel installed permanently on your car?

    Definitely don’t connect a 24V source directly to your cars 12V system. There’s a good chance of frying something important. A fuse would not protect from overvoltage so don’t rely on those to protect components.


  • I lived in an area that was going to start strip mining for sand that was the right consistency for fracking. Plenty of conservatives were amongst the loudest opponents. There’s plenty of hypocracy, no need to exaggerate. Their reasons were not wanting to have so much heavy equipment on the roads and fear of silicosis, not opposing natural gas extraction.









  • Plus all the helicopter pilots for remote industrial work. Have you seen the logging helicopters? There’s helicopters for inspecting and servicing electrical transmission lines. Some power companies use giant dangling saws attached to a helicopter to trim trees along lines.

    If you only included passenger aviation, I bet the count would be below average, with most fatalities being from medical conditions while on the job.




  • 4 times in the last 5 years.

    There’s a combination of flaws. The strainer basket doesn’t do a very good job keeping debris out of the impeller. There’s little separation between the steainer and the impeller. So long hairs that are partially caught in the strainer can still wrap around the impeller.

    The pump itself has a terrible impeller design. The impeller is nylon and is press fit onto a 1/8 brass rod that just has a flat ground on it, no knurling or splines. The nylon cracks easily and ends up free spinning.

    They use the same pump in loads of washer models. So yes, there’s a very large user base, but that’s a lot of people with part failures. The pump is garbage and lg should not be using it.