I’ve been doing functional ABS and ASA lately and had a couple very annoying warpage spots. One was a total failure. (We won’t talk about the other 3 failures that were wet out-of-the-box Bambu ASA…)

The X1C is definitely nice, but the all aluminum-and-glass side panelling has a sometimes-unwanted side effect: thermal conduction.
The aluminum sides are so conductive that they do not allow the chamber temp to go above 40C, even after a couple hours of heat soaking the build plate at 100C before starting an ABS print.
Enter: One random bath towel. doesn’t look like much but just covering the three sides with a thin layer means it’s good enough insulation to get the chamber up to 50C now! And the ABS parts look better than ever- every C counts.

  • teotwaki@lemmy.world
    link
    fedilink
    English
    arrow-up
    7
    ·
    4 months ago

    Interesting that the extra 10° makes such a difference for ASA and ABS.

    I recently started printing with ASA in my enclosed MK4. I might have to try this.

    • empireOfLove2@lemmy.dbzer0.comOP
      link
      fedilink
      English
      arrow-up
      3
      ·
      4 months ago

      It makes all the difference, especially on asa. They’re so sensitive to chamber temp and accidental fan use it’s actually kinda nuts. I’m really happy with the part’s physical strength and behavior of course but it’s a very different beast compared to PLA, which will basically still make a successful print even if half of the model isn’t even touching the bed lol.

      If you can get the chamber to 50-60C it’s ideal for those. 40 you can often get away with but on larger parts it is marginal at best.

    • Synapse@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      4 months ago

      I was successful with ASA using my MK3 inside the IKEA LACK enclosure. Although those were small parts, not subject to much wrapping.