• Flaky_Fish69@kbin.social
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    some questions- I’m not really sure I have a firm grasp of what’s happening… can you provide more pictures with different angles? and maybe some nifty circles or something so we know what you’re looking at?

    I do see what might be some underextrusion going on in the top infil near the upper half (above the center hole?) that I don’t see in the bottom half of that same infil. If your bed isn’t perfectly level, that could cause that. (as the high side would squish the filament a bit more.

    the other thing that’s standing out is the not-solid infill has the almost molten appearance of being too hot? that could definitely just be the picture, mind you, but if you haven’t, I’d run a temp tower test. I like this model,

    • keeb420@kbin.socialOP
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      Here’s hopefully a better picture. It’s the bottom of the pic. One side appears mostly fine but with some blemishes. The bottom which should have the same texture looks very rough like filament is missing.